OBD II Fault Code P1F42 :

Description of Fault code P1F42

BVCM Internal Element Drive Signal Error

Possible failuer P1F42

• BVCM U-phase Boost-side Element or Element Drive Signal Serial Line failure
• BVCM U-phase Buck-side Element or Element Drive Signal Serial Line failure
• BVCM V-phase Boost-side Element or Element Drive Signal Serial Line failure
• BVCM V-phase Buck-side Element or Element Drive Signal Serial Line failure
• BVCM W-phase Boost-side Element or Element Drive Signal Serial Line failure
• BVCM W-phase Buck-side Element or Element Drive Signal Serial Line failure
• FCVSCM failure

Diagnostic Procedure using AutoHex II Scan Tool

• The rear average wheel speed > 15km/h and vehicle speed on the meter<1km/h
• If the rear average wheel speed > 15km/h and VSP<1km/h lasts for 0.3 seconds, the malfunction is determined.

Test Conditions using AutoHex tester

• Vehicle speed / wheel speed is normal
• Brake is out of action
• The automatic brake is out of action

Clear Fault codes Conditions

• The rear average wheel speed > 15km/h and vehicle speed on the meter<1km/h
• If the rear average wheel speed > 15km/h and VSP<1km/h lasts for 0.3 seconds, the malfunction is determined.

MIL Status

• Glow ON

Note:

• AutoHex II is a professional Auto diagnostic.
• This fault code is a GERENRIC fault code, some cars may change the meaning of this fault code.
  To get the accurate fault code description you may use AutoHex II

More Fault codes: