OBD II Fault Code P0716 :

Description of Fault code P0716

CVT INPUT SHAFT (DRIVE PULLEY) SPEED SENSOR CIRCUIT RANGE/PERFORMANCE

Possible failuer P0716

• Sensor failure
• Signal line open/short

Diagnostic Procedure using AutoHex II Scan Tool

• The malfunction is detected when the Engine is started, the voltage from IG1 is more than 10.5V, and the input voltage from VBU to TCM is less than 6V, at least 2 seconds.

Test Conditions using AutoHex tester

• ENGINE SPEED > 400rpm
• Battery Voltage > 10.5V

Clear Fault codes Conditions

• The malfunction is detected when the Engine is started, the voltage from IG1 is more than 10.5V, and the input voltage from VBU to TCM is less than 6V, at least 2 seconds.

MIL Status

• ON

Note:

• AutoHex II is a professional Auto diagnostic.
• This fault code is a GERENRIC fault code, some cars may change the meaning of this fault code.
  To get the accurate fault code description you may use AutoHex II

More Fault codes: