OBD II Fault Code B1160 :

Description of Fault code B1160

Gauge control module lost communication with Door Multiplex control unit (door lock switch message)

Possible failuer B1160

Gauge Control Module

Diagnostic Procedure using AutoHex II Scan Tool

• The low level of the ignition signal is detected at initializing Engine Control Module (ECM). (The Engine Control Module (ECM) started without input of the ignition signals.)

Test Conditions using AutoHex tester

• The Engine Control Module (ECM) is initialized
• The Engine Control Module (ECM) reset by the program malfunction and the Engine Control Module (ECM) internal hardware malfunction isn't executed.

Clear Fault codes Conditions

• The low level of the ignition signal is detected at initializing Engine Control Module (ECM). (The Engine Control Module (ECM) started without input of the ignition signals.)

MIL Status

• Glow ON

Note:

• AutoHex II is a professional Auto diagnostic.
• This fault code is a GERENRIC fault code, some cars may change the meaning of this fault code.
  To get the accurate fault code description you may use AutoHex II

More Fault codes: